How to Prevent DTF Printer Nozzle from Burning Out
Everyone knows that the value and function of the nozzle of the white ink heat transfer printing machine are very high, and the nozzle is also an indispensable part in the operation of the white ink heat transfer printing machine. Sometimes the nozzle burns out without knowing why. Especially in the process of disassembling and assembling, the nozzle is most prone to this phenomenon. How to prevent the nozzle of the white ink heat transfer printing machine from being burned out?
The nozzle of the white ink heat transfer printing machine should be powered off when it is installed. If it is operated under the power-on state, it is easy to break the nozzle. After installation, gently push the car to move left and right to check whether it is smooth. It has been installed in place, and only then can it be powered on.
Do not install ink temporarily when the white ink heat press printing machine is powered on, and then check whether there is any bad contact, otherwise the white ink heat press printing machine nozzle will burn out due to a short circuit. The surface of the nozzle of the white ink heat transfer printing machine should be protected. Do not collide, so as not to cause damage and deformation, which will affect the normal operation of the printing machine. At this time, you can add ink, check the amount of ink, the ink pump, and the cleaning sheet one by one. Note: Most of the nozzles of the white ink heat transfer printing machine installed for the first time have air inside, so it is necessary to print a small sample of the picture first to discharge the air, and then perform normal printing work.